Panasonic KX-FLB802CX

49
KX-FLB802CX/KX-FLB812CX/KX-FLB802CXS/KX-FLB812CXS
6.13. SENSORS AND SWITCHES SECTION
All of the sensor and switches are shown below.
Note:
See TEST FUNCTIONS - SENSOR CHECK SECTION for the sensor test.
(#815 of Service Mode test. Refer to TEST FUNCTIONS (P.92).
6.13.1. DRUM SENSOR
This Switch detects whether the DRUM unit is set or not.
When there is the unit, the input signal of IC600-M18pin becomes low level.
When there is not the unit, the input signal of IC600-M18pin becomes high level.
Sensor Name Sensor Location Reference number Message Error
Drum sensor Sensor PCB SW2 [CHECK DRUM]
Paper sensor Sensor PCB SW3 [OUT OF PAPER INPUT TRAY #1]
Pickup sensor Sensor PCB SW4
Exit sensor Thermistor PCB PS5 [PAPER JAMMED]
Home sensor FB Transit PCB PS51 [CARRIAGE ERROR]
Read position sensor Sensor PCB PS2 [CHECK DOCUMENT]
Registration & Manual paper sen-
sor
Sensor PCB PS4 [PAPER JAMMED]
Print timing sensor Sensor PCB PS3 [PAPER JAMMED]
Document sensor Sensor PCB PS1 -
ADF cover sensor Sensor PCB SW1 [CLOSE ADF COVER]
Top cover sensor H.V.P.S SW1 [TOP COVER OPEN]
Toner sensor Sensor PCB IC40 [TONER EMPTY]
[TONER LOW]
[CHECK DRUM]
Option handset hook switch Op handset PCB SW940 -
Signal (IC600-M18pin)
Drum Set Low level
No Drum High level