Panasonic KX-FLB802CX

29
KX-FLB802CX/KX-FLB812CX/KX-FLB802CXS/KX-FLB812CXS
Note 1 - Standard facsimile units conforming to T.2 must have the following capability: Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability: Index of cooperation (IOC)=264.
Note 3 - Standard facsimile units conforming to T.4 must have the following capability: Paper length=297 mm.
21, 22, 23
(0, 0, 0)
(0, 0, 1)
(0, 1, 0)
(1, 0, 0)
(0, 1, 1)
(1, 1, 0)
(1, 0, 1)
(1, 1, 1)
Minimum scan line time capability of the receiver
20 ms at 3.85 l/mm: T
7.7
= T
3.85
40 ms at 3.85 l/mm: T
7.7
= T
3.85
10 ms at 3.85 l/mm: T
7.7
= T
3.85
5 ms at 3.85 l/mm: T
7.7
= T
3.85
10 ms at 3.85 l/mm: T
7.7
= 1/2 T
3.85
20 ms at 3.85 l/mm: T
7.7
= 1/2 T
3.85
40 ms at 3.85 l/mm: T
7.7
= 1/2 T
3.85
0 ms at 3.85 l/mm: T
7.7
= T
3.85
Minimum scan line time
20 ms
40 ms
10 ms
5 ms
0 ms
24 Extend field Extend field
25 2400 bit/s handshaking 2400 bit/s handshaking
26 Uncompressed mode Uncompressed mode
27 Error correction mode Error correction mode
28 Set to “0”. Frame size 0 = 256 octets 1 = 64 octets
29 Error limiting mode Error limiting mode
30 Reserved for G4 capability on PSTN Reserved for G4 capability on PSTN
31 T.6 coding capability T.6 coding enabled
32 Extend field Extend field
33
(0)
(1)
Validity of bits 17, 18
Bits 17, 18 are valid
Bits 17, 18 are invalid
Recording width
Recording width indicated by bits 17, 18
Recording width indicated by this field bit information
34 Recording width capability 1216 picture elements along
scan line length of 151 ± mm 1%
Middle 1216 elements of 1728 picture elements
35 Recording width capability 864 picture elements along scan
line length of 107 ± mm 1%
Middle 864 elements of 1728 picture elements
36 Recording width capability 1728 picture elements along
scan line length of 151 ± mm 1%
Invalid
37 Recording width capability 1728 picture elements along
scan line length of 107 ± mm 1%
Invalid
38 Reserved for future recording width capability.
39 Reserved for future recording width capability.
40 Extend field Extend field
41 R8×15.4 lines/mm R8×15.4 lines/mm
42 300×300 pels/25.4 mm 300×300 pels/25.4 mm
43 R16×15.4 lines/mm and/or 400×400 pels/25.4 mm R16×15.4 lines/mm and/or 400×400 pels/25.4 mm
44 Inch based resolution preferred Resolution type selection
“0”: neuritic based resolution
“1”: inch based resolution
45 Metric based resolution preferred Don’t care
46 Minimum scan line time capability for higher resolutions
“0”: T
15.4
= T
7.7
“1”: T
15.4
= 1/2T
7.7
Don’t care
47 Selective Polling capability Set to “0”.
48 Extend field Extend field
Signal Identification Signal Format Function
Training 1 ——————— A fixed pattern is transmitted to the receiving side at a speed (2400
to 14400 bps) designated by DCS, and the receiving side optimizes
the automatic equalizer, etc., according to this signal.
Bit No. DIS/DTC DCS