73
KX-FLB802CX/KX-FLB812CX/KX-FLB802CXS/KX-FLB812CXS
8.1.3.1. For KX-FLB812 users
As a default setting, printed paper is stacked on the output tray as follows.
- Upper output tray (“#1”): Printed document by using the computer and copied document.
- Lower output tray (“#2”): Received fax document.
• You can change the output tray setting for faxing (feature #441) and for copying (feature #466).To change the output tray from
the computer, set the printer properties.
Note:
• The upper output tray can hold up to approximately 100 sheets of printed paper. The lower output tray can hold up to approxi-
mately 50 sheets of printed paper. Remove the printed paper before the output tray becomes full.
1.
Insert the output tray (1) into the slots (2), then push the tray down until
it latches into place.
2.
Pull the output tray extender (1) forward gently until it clicks into
place, then press the center part of the extender (2) to open.
• Repeat from step 1 to install the upper output tray.
To Next Page
Loading...
