Panasonic KX-FLB802CX

86
KX-FLB802CX/KX-FLB812CX/KX-FLB802CXS/KX-FLB812CXS
8.1.8. INSTALLING MULTI-FUNCTION STATION
• The screenshots shown in these instructions are for Windows XP and are included for reference only.
• The screenshots shown in these instructions may differ slightly from those of the actual product.
• Software features and appearance are subject to change without notice.
1. Start Windows and exit all other applications.
• For Windows XP and Windows 2000 users, you must be logged in as an administrator in order to install Multi-Function Station.
• Install Multi-Function Station before connecting the unit to a computer. If the unit is connected to a computer before
installing Multi-Function Station, the [Found New Hardware Wizard] dialog box will appear. Click [Cancel] to close it.
2. Insert the included CD-ROM into your CD-ROM drive.
• The [Choose Setup Language] dialog box will appear. Select the desired language that you want to use with this software from
the drop-down list. Click [OK]. The installation will automatically start.
• If the [Choose Setup Language] dialog box does not appear:
The installation will automatically start.
• If the installation does not start automatically:
Click [Start]. Choose [Run...]. Type “D:\setup” (where “D:” is the drive letter of your CD-ROM drive). Click [OK].
(If you are not sure what the drive letter is for your CD-ROM drive, use Windows Explorer and look for the CD-ROM drive.)
The installation will start.
3. When the setup program starts, follow the on-screen instructions.
4. When the [Setup Type] dialog box appears, select [Standard], then click [Next].
• Readiris OCR software and Device Monitor will also be installed.
5. When the [Connect Type] dialog box appears, select [Connect directly with a USB cable.], then click [Next].
• The [Connect Device] dialog box will appear.
6. Connect the unit with the USB cable, then click [Next].
• If the unit is connected to your computer, the model name will be automatically detected.
• You can change the names for the printer, PC fax, and scanner if necessary.
7. Click [Install], then follow the on-screen instructions.
• The files will be copied to your computer.
Important notice for Windows XP users
• If you use Windows XP, the following message may appear after step 6:
“The software you are installing for this hardware has not passed Windows Logo testing to verify its compatibility with Windows
XP”
This is normal and the software will not cause any difficulties with your operating system. You can continue the installation with
no problem.
Note:
• If the screen prompts to insert the CD-ROM for operating system when installing Multi-Function Station, insert it into your CD-
ROM drive.