Panasonic KX-FLB802CX

93
KX-FLB802CX/KX-FLB812CX/KX-FLB802CXS/KX-FLB812CXS
Note:
The numbers in the boxes (XXX) indicate the keys to be input for the various test modes.
SENSOR CHECK Service Mode “8” “1” “5” First of all, press the copy button, and confirm the action of ON/OFF.
For each sensor’s operation, refer to SENSORS AND SWITCHES SECTION
(P.49).
LCD DISPLAY:
D: Document
D: Document set
-: No document
S: Read position
S: Docu detect
-: No document
C: Top cover
C: Cover open
-: Cover close
P: Paper
P: Paper set
-: No paper
R: Registration
R: Paper detect
-: No paper
E: Sorter enter
E: Paper detect
-: No paper
D: Drum
D: DRUM set
-: No DRUM
T: Toner
T: Toner detect
-: No toner
*: None
3F: Fuser thermistor
3F: 00 (high temp.) - FF (low temp.)
*: None
DF: Fuser thermistor
DF: 00 (high temp.) - FF (low temp.)
*: None
V: VOX
V: VOX detect
-: No VOX
*: None
U: Pickup
U: Paper detect
-: No paper
T: Print timing
T: Paper detect
-: No paper
F: FB cover
F: Cover open
-: Cover close
A: ADF cover
A: Cover open
-: Cover close
H: Home
H: CIS at Home position
-: CIS not at Home position
*: None
*: None
*: None
*: None
*: None
*: None
*: None
*: None
*: None
*: None
PRINT TEST PAT-
TERN
Service Mode “8” “5” “2” 1. Press “852” then the SET key in the service mode.
2. As “PATNO =” is displayed on the LCD, enter the test pattern No. and press the
SET key.
3. When “No. = “is displayed on the LCD, enter the printing number and press the
SET key. (Press “00” for the infinite printing.)
4. “MODE” is displayed on the LCD. Press “0” to start printing or press “1” to go to
the next screen.
5. When “1” is pressed at MODE, “INTVL = “is displayed on the LCD. Enter the
printing interval (00~99 sec).
6. The printing repeats the designated number of times at the programmed print-
ing intervals.
Test Mode Type of Mode Code Function
Operation after code
input