Panasonic KX-FP215

159
KX-FP215
15.1.2.1. Maintenance List
15.1.2.2. Maintenance Cycle
Note:
*
1
These values are standard and may vary depending on usage conditions.
*
2
Refer to Cabinet, Mechanical and Electrical Parts Location (P.197).
No. OPERATION CHECK REMARKS
1 Document Path Remove any foreign matter such as paper. —
2 Rollers If the roller is dirty, clean it with a damp cloth then dry thor-
oughly.
Refer to Document feeder/recording paper
feeder/scanner glass cleaning (P.169).
3 Platen Roller If the platen is dirty, clean it with a damp cloth then dry
thoroughly. Remove the paper and film cartridge before
cleaning.
—
4 Thermal Head If the thermal head is dirty, clean the printing surface with a
cloth moistened with denatured alcohol (alcohol without
water), then dry thoroughly.
Refer to Thermal Head Cleaning (P.170).
5 Sensors Confirm the operation of the following sensors.
• Document top sensor (SW351) on the Operation Board
• Document set sensor (SW352) on the Operation Board
• Film detection sensor (SW102) on the Sensor Board
• Cover open sensor (SW1001) on the Sensor Board
• Paper top sensor (SW1001) on the Interface Board
• Film end sensor (SW1003) on the Film End Sensor
Board
See Component Locations (P.158) .
6 Glass If the glass is dirty, clean them with a dry soft cloth. Refer to Document feeder/recording paper
feeder/scanner glass cleaning (P.169).
7 Abnormal, wear and tear
or loose parts
Replace the part. Check if the screws are tight on all parts. —
No. Item Cleaning Cycle Replacement
Cycle Procedure
1
Separation Roller (Ref. No. 145)*
2
3 months
7 years*
1
(31,500 documents)
Refer to How to Remove the Gear Block and
Separation Roller (P.143).
2 Separation Rubber (Ref. No. 13) 3 months 7 years (31,500 documents) Refer to How to Remove the Separation Holder
and Exit Roller (P.153).
3 Feed Rollers (Ref. No. 11, 56, 94) 3 months 7 years (31,500 documents) Refer to Document feeder/recording paper
feeder/scanner glass cleaning (P.169).
4 Thermal Head (Ref. No. 40) 3 months 7 years (31,500 documents) Refer to How to Remove the Thermal Head
(P.138).
5 Platen Roller (Ref. No. 90) 3 months 7 years (31,500 documents) Refer to How to Remove the Platen Roller and
Lock Lever (P.148).
6 Pickup Roller (Ref. No. 96) 3 months 7 years (31,500 documents) Refer to How to Remove the Pickup Roller
(P.150).