57
KX-FP215
9 Operating Instructions
9.1. Setting Your Logo
You can program your logo (name, company name, etc.) so
that it appears on the top of each page sent.
1. [MENU] → [#][0][2] → [SET]
2. Enter your logo, up to 30 characters. See the following
character table for details. → [SET]
3. Press [MENU] to exit.
To select characters with the dial keypad
Note:
• To enter a character that is located on the same dial key as
the previously entered character, you must first press [] to
move the cursor to the next space.
To enter your logo
Example: “BILL“
1. Press [2] 5 times.
2. Press [4] 6 times.
3. Press [5] 6 times.
4. Press [] to move the cursor to the next space and
press [5] 6 times.
To correct a mistake
Press [] or [] to move the cursor to the incorrect char-
acter, and make the correction.
• To erase all of the characters, press and hold [STOP].
To Next Page
Loading...
