Panasonic KX-FP215

97
KX-FP215
OK means "can set".
NG means "can not set".
Note:
•
*1
: Power is OFF/ON after changing this set value.
• Refer to Service Function Table (P.63) for descriptions of the individual codes.
Example:
If you want to set value in the "004 Print confirmation report", press the dial key number 1,2 or 3 corresponding to the Set Value
you want to select. (1:ERROR / 2:ON / 3:OFF)
571 ITS auto redial time set 00~99 00 OK
572 ITS auto redial line disconnection time set 001~999 sec 065 sec OK
573 Remote turn-on ring number 01~99 10 OK
574 Dial tone detect check 1: ON / 2: OFF OFF OK
580 TAM continuous tone detection 1: ON / 2: OFF ON OK
590 FAX auto redial time set 00~99 01 OK
591 FAX auto redial line disconnection time set 001~999 sec 065 sec OK
592 CNG transmit select 1:OFF / 2:ALL / 3:AUTO ALL OK
593 Time between CED and 300 bps 1: 75 ms / 2: 500 ms / 3: 1 sec 75 ms OK
594 Overseas DIS detection 1: 1st / 2: 2nd 1st OK
595 Receive error limit value 1: 5% / 2: 10% / 3: 15% / 4: 20% 10% OK
596 Transmit level set -15~00 dbm -10 dbm OK
598
*1
Receiving Sensitivity -20~-48 dbm -42 dbm OK
599 ECM Frame size 1: 256 byte / 2: 64 byte 256 byte OK
625 Setting printing density 1: Default / 2: Lighter / 3: Darker Default OK
710 Memory clear except History data --------- --------- NG
717 Transmit speed select 1: 14400 / 2: 12000 / 3: 9600 / 4: 7200 /
5: 4800 / 6: 2400 bps
14400 bps OK
718 Receive speed select 1: 14400 / 2: 12000 / 3: 9600 / 4: 7200 /
5: 4800 / 6: 2400 bps
14400 bps OK
722 Redial tone detect 1: ON / 2: OFF OFF OK
732 Auto disconnect 1: 2 sec / 2: 4 sec / 3: OFF 2 sec OK
745 Power on film feed 1: ON / 2: OFF ON OK
763 CNG detect time for friendly reception 1: 10 sec / 2: 20 sec / 3: 30 sec 30 sec OK
773
DIS-DCS interval
1: 500 msec / 2: 200 msec 200 msec OK
774 T4 timer 00~99 x 100 msec 00 msec OK
784 Voice prompt --------- --------- NG
815 Sensor & VOX test --------- --------- NG
841 Digital SP-Phone RX & TX check --------- --------- NG
852 Print test pattern --------- --------- NG
853 Top margin 1~9 mm 5 mm OK
874 DTMF ON time 06~20 × 10 msec 10 × 10 msec OK
875 DTMF OFF time 06~20 × 10 msec 10 × 10 msec OK
880 History list 1:Start --------- NG
881 Journal 2 1:Start --------- NG
882 Journal 3 1:Start --------- NG
991 Remote Setup list 1:Start --------- OK
994 Remote Journal list 1:Start --------- OK
995 Remote Journal 2 list 1:Start --------- OK
996 Remote Journal 3 list 1:Start --------- OK
998 Remote History list 1:Start --------- OK
999 Remote Service list 1:Start --------- OK
Code Function Set Value Default Remote Set-
ting