Default Value
N
PERIODIC_INFORM_INTERVAL
Value Format INTEGER
Description Specifies the interval length, in seconds, when the CPE must attempt
to connect with the ACS and call the Inform method.
Note
• This setting is available only when
"PERIODIC_INFORM_ENABLE" is set to "Y".
Value Range 30–2419200
Default Value 86400
PERIODIC_INFORM_TIME
Value Format STRING
Description Specifies the time (UTC) to determine when the CPE will initiate the
periodic Inform method calls.
Note
• Each Inform call must occur at this reference time plus or
minus an integer multiple of the
"PERIODIC_INFORM_INTERVAL". This
"PERIODIC_INFORM_TIME" parameter is used only to set the
"phase" of the periodic Informs. The actual value can be
arbitrarily set far into the past or future.
For example, if "PERIODIC_INFORM_INTERVAL" is set to
86400 (one day) and if "PERIODIC_INFORM_TIME" is set to
midnight on a certain day, then periodic Informs will occur
every day at midnight, starting from the set date.
• If the time is set to "unknown time", the start time depends on
the CPE’s settings. However, the
"PERIODIC_INFORM_INTERVAL" must still be adhered to.
If absolute time is not available to the CPE, its periodic Inform
behavior must be the same as if the
"PERIODIC_INFORM_TIME" parameter was set to the
"unknown time".
• Time zones other than UTC are not supported.
Value Range 4–32 characters
date and time format
Default Value 0001-01-01T00:00:00Z
CON_REQ_USER_ID
Value Format STRING
Description Specifies the user name used to authenticate an ACS making a
Connection Request to the CPE.
Value Range Max. 256 characters
5.3.9 TR-069 Settings
228 Administrator Guide Document Version: 2017-07
To Next Page
Loading...
