Panasonic KX-HDV230 - Page 297

Value Range 3–50 (× 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than "NOM_DELAY"
– This value must be greater than "MIN_DELAY"
– "NOM_DELAY" must be greater than or equal to
"MIN_DELAY"
Default Value 20
MIN_DELAY_n
For details about parameter names end with "_n", see 5.2.1 Configuration File Parameters
Value Format INTEGER
Description Specifies the minimum delay, in 10-millisecond units, of the jitter
buffer.
Value Range 1 or 2 (× 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be less than or equal to "NOM_DELAY"
– This value must be less than "MAX_DELAY"
– "MAX_DELAY" must be greater than "NOM_DELAY"
Default Value 2
NOM_DELAY_n
For details about parameter names end with "_n", see 5.2.1 Configuration File Parameters
Value Format INTEGER
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range 1–7 (× 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than or equal to "MIN_DELAY"
– This value must be less than "MAX_DELAY"
Default Value 1
RTP_PORT_MIN
Value Format INTEGER
Description Specifies the lowest port number that the unit will use for RTP
packets.
Value Range 1024–59598 (only even)
5.3.26 RTP/RTCP/RTCP-XR Settings
Document Version: 2017-07 Administrator Guide 297