Panasonic KX-HDV230 - Page 300

Value Range
• 0: SRTP
• 1: RTP/SRTP
• 2: Panasonic Original
• 3: SRTP/RTP
Note
• 0: Use only SRTP for outgoing and incoming calls.
• 1: Use only RTP for outgoing calls, and RTP or SRTP for
incoming calls.
• 2: Use RTP or SRTP for both outgoing and incoming calls.
This value is valid only when the unit is connected to a
Panasonic PBX.
"SRTP_MIX_TRANSFER_ENABLE_n" must also be set to "Y".
• 3: If you are using "RTP/AVP" and append "a=crypto", and the
response message includes "a=crypto", the conversation will
be established with SRTP. If "a=crypto" is not included, the
conversation will be established with RTP.
Default Value 1
Web User Interface Reference SRTP Mode
SRTP_MIX_CONFERENCE_ENABLE_n
For details about parameter names end with "_n", see 5.2.1 Configuration File Parameters
Value Format BOOLEAN
Description Specifies whether to allow conferences where each participant can
use either SRTP or RTP.
Value Range
• Y: Enable
• N: Disable
Default Value
N
Web User Interface Reference Enable Mixed SRTP & RTP by Conference
SRTP_MIX_TRANSFER_ENABLE_n
For details about parameter names end with "_n", see 5.2.1 Configuration File Parameters
Value Format BOOLEAN
Description Specifies whether to allow call transfers between a user who is using
SRTP and a user who is using RTP.
Value Range
• Y: Enable
• N: Disable
Default Value
N
Web User Interface Reference Enable Mixed SRTP & RTP by Transfer
5.3.27 SRTP Settings
300 Administrator Guide Document Version: 2017-07