• Up to 2 SNMP managers can be assigned.
• This PBX supports SNMP Protocol Version 1.0 and SNMP Version 1.0-TRAP.
• This PBX can only receive read-only MIBs. Write MIBs are not supported.
• This PBX supports MIB II.
• For more
information regarding major and minor alarms, refer to 5.1.5 Troubleshooting by Error Log in the
Installation Manual.
• For a list of the MIB object groups supported by this PBX, refer to 3.3 Supported Management Information
Base (MIB) Table in the Appendix.
• Through system programming, it is possible to select whether each type of TRAP (e.g., ColdStart) is sent
to the SNMP manager or not.
PC Programming Manual References
13.4 [11-4-1] SNMP—System Setting
13.5 [11-4-2] SNMP—Manager
Feature Guide References
2.4.3 Local Alarm Information
Feature Guide 441
2.4.4 Simple Network Management Protocol (SNMP) System Monitor
To Next Page
Loading...
