2.4.5 Dynamic Host Configuration Protocol (DHCP) Assignment
Description
It
is
possible to assign this PBX as a Dynamic Host Configuration Protocol (DHCP) client, allowing IP addresses
to be received from a DHCP server over a LAN.
Conditions
• It is possible to enable this feature through system programming.
Notice
It is important to set your DHCP server to not change the IP addresses of the IPCMPR/IPCEMPR and
DSP cards once IP telephones are registered to the PBX. The IP telephones will not operate properly if
these IP addresses are changed.
PC Programming Manual References
3.4 [1-1] Slot—Card Property - IPCMPR—LAN Setting
→
DHCP Client
→ IP Address for IPCMPR Card
→ IP Address for VoIP-DSP
442 Feature Guide
2.4.5 Dynamic Host Configuration Protocol (DHCP) Assignment
To Next Page
Loading...
