4. Program the SIP Extension you wish to register.
[For SIP Extensions (except KX-HGT100)]
a. Set the IP address of the MPR card, extension
number, and password in the corresponding fields
for your SIP Extension.
b. Send a request from the SIP Extension to the PBX
for registration.
• If the authentication information of the SIP
Extension and the PBX match, the
registration is successful.
Note
• When programming the SIP Extension, the
names of the corresponding fields may differ
depending on the type of SIP Extension you
are using.
• For details about the actual operation of SIP
Extensions, refer to the documentation of the
SIP Extension.
• For certain SIP Extensions, you may need to
set a Sign-in name, which should consist of
the extension number and the IP address of
the MPR card (e.g., 350@192.168.0.101).
[For KX-HGT100 SIP Telephones]
It is necessary to program the KX-HGT100 through Web Programming to register to the PBX.
Follow the procedures below to prepare your PC for Web Programming and program the KX-HGT100.
Preparing the PC
System Requirements
• Microsoft
®
Internet Explorer
®
6.0 or later
Trademarks
• Microsoft, Windows, and Internet Explorer are either registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other countries.
• All other trademarks identified herein are the property of their respective owners.
Note
The procedures vary depending on the operating system of the PC.
This example is based on the Windows
®
XP operating system.
1. Open Control Panel from the Start menu.
92 IP Networking Guide Document Version 2010-08
4.6.1 Registering IP Telephones
To Next Page
Loading...
