Panasonic KX-NS300 - Page 30

6. In the LAN settings:
The IP addresses for the PBX, DNS server, and DSP
cards can be assigned automatically through a DHCP
server or entered manually.
When using a DHCP server:
a. Select Obtain an IP address automatically.
b. Select Obtain DNS server address automatically.
c. Select Obtain DSP IP address automatically.
Notice
The boxes will turn grey and the IP address
information will be assigned automatically.
Write down the address information assigned to
the PBX for future reference.
d. Click Next.
When not using a DHCP server:
a. Select Use the following IP address.
b. Enter an IP address
*1
, subnet mask
*2
, and default
gateway
*1
. (You may not need to specify the default
gateway, depending on your network configuration.)
c. Select Use the following DNS server address.
d. Enter the preferred and alternative DNS IP
addresses
*1
.
e. Select Use the following DSP IP address.
f. Enter IP address
*1
for installed DSP card.
g. Click Next.
*1
Valid IP address range: "1.0.0.1" to "223.255.255.254"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255"
(except "0.0.0.0" and "255.255.255.255")
30 Getting Started
4.1.1 Easy Setup Wizard