Panasonic KX-NS700 - Page 493

Conditions
• Voice data (RTP packets) from remote extensions connected to the PBX via the built-in Media Relay
Gateway cannot be sent via a P2P connection. Instead, these calls are connected using the RTP switch
method.
• IP Softphones connected from a remote location via the Media Relay Gateway do not support the following
features:
– Paging (2.17.1 Paging)
– Background Music (2.30.1 Background Music (BGM))
• For KX-UT SIP phones, extensions that will be configured remotely use HTTPS for transferring the
configuration file. However, a maximum of 20 extensions per site can be connected in this way.
Installation Manual References
5.8.3 Installing SIP Phones at a Remote Site with an External SBC
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway
PC Programming Manual References
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—SIP Extension
→ Setting parameters assigned to Remote SIP-MLT—NAT - CWMP Server IP Address
→ Setting parameters assigned to Remote SIP-MLT—NAT - CWMP Server (HTTP) Port No.
→ Setting parameters assigned to Remote SIP-MLT—NAT - CWMP Server (HTTPS) Port No.
→ Setting parameters assigned to Remote SIP-MLT—NAT - SIP-MLT Data Download Server (HTTP)
Port No.
→ Setting parameters assigned to Remote SIP-MLT—NAT - SIP-MLT Data Download Server (HTTPS)
Port No.
→ Setting parameters assigned to Remote SIP-MLT—NAT - SIP Proxy Server IP Address
→ Setting parameters assigned to Remote SIP-MLT—NAT - SIP Proxy Server Port No.
→ Setting parameters assigned to Remote SIP-MLT—NAT - NTP Server IP Address
→ Setting parameters assigned to Remote SIP-MLT—NAT - NTP Server Port No.
→ Setting parameters assigned to Remote SIP-MLT—NAT - Keep Alive Packet Type
→ Setting parameters assigned to Remote SIP-MLT—NAT - Keep Alive Packet Sending Interval Time
(s)
→ Setting parameters assigned to Remote SIP-MLT—NAT - SIP Register Expire Time (s)
→ Setting parameters for Networking Survivability, assigned to Remote SIP-MLT—NAT - CWMP Server
IP Address
→ Setting parameters for Networking Survivability, assigned to Remote SIP-MLT—NAT - CWMP Server
(HTTP) Port No.
→ Setting parameters for Networking Survivability, assigned to Remote SIP-MLT—NAT - CWMP Server
(HTTPS) Port No.
→ Control Condition of Remote SIP-MLT—PERIODIC Ability
→ Control Condition of Remote SIP-MLT—PERIODIC Packet Sending Interval Time (s)
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Port Number— Firmware
Update Port No. for IP-PT/IP-CS (Media Relay)
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Media Relay
→ Common—NAT - External IP Address
→ IP Extension / IP-CS—NAT - MGCP Server Port No.
→ IP Extension / IP-CS—NAT - MGCP Server Port No. for IP-CS
→ IP Extension / IP-CS—Keep Alive Packet Type
→ IP Extension / IP-CS—Keep Alive Packet Type for IP-CS
→ IP Extension / IP-CS—Keep Alive Packet Sending Interval Time (s)
→ IP Extension / IP-CS—NAT - FTP Server Port No.
Feature Manual 493
5.2.2 SIP (Session Initiation Protocol) Extension