4.2 Programming the VoIP Gateway Card in the Los Angeles Office
Getting Started 39
4.2.8 Confirming the IP Address Assignment
After programming of the VoIP Gateway Card is finished, try to access the card with the new
IP addressing information. If you can connect to the card without problems, the card can be
placed on the LAN for VoIP operations (see "2.2.2 Connection to the LAN" or "3.2.2 Connection
to the LAN").
Follow the procedure below, referring to "4.1.1 Preparing the PC" and "4.2.1 Starting the IP-
GW4 Maintenance Utility".
1. Set the IP address settings of the PC to the following values:
• IP address: 200.45.11.100
• Subnet Mask address: 255.255.255.0
2. Start Internet Explorer from the Start menu.
3. In the Address box of Internet Explorer, type http://200.45.11.35 (the new IP address of
the card).
4. Press the ENTER key on the keyboard.
If you can log in, then the card has been successfully programmed.
After you have confirmed that the card has been successfully programmed, it is strongly
recommended that you download the configuration data from the card and save it on your PC
for backup and archive purposes.
The procedure for downloading the configuration data is provided in "2.4.2 Download of
Configuration Data" of the VoIP Gateway Card Programming Guide.
To Next Page
Loading...
