D1 Considerations in Installation
74 Getting Started
D1 Considerations in Installation
Provided below are the points to consider when the VoIP network contains both the KX-
TDA5480/KX-TDA0484 and KX-TDA0480 VoIP Gateway Cards.
Adding the KX-TDA5480/KX-TDA0484 to the Network Using the KX-TDA0480
Maintenance Console Software
For the KX-TDA0480 to recognize the KX-TDA5480/KX-TDA0484 in the network, you must add
it as an "Other Unit" in a Unit Group (network) when programming with the MCS as shown
below:
Note
For programming instructions and other information about the KX-TDA0480, refer to the
documentation for the KX-TDA0480.
Restrictions on Feature Compatibility
Some restrictions exist when using the KX-TDA5480/KX-TDA0484 with the KX-TDA0480, as
detailed below:
• CLIP service is the only QSIG service available between the KX-TDA5480/KX-
TDA0484 and KX-TDA0480. There is no compatibility for other QSIG services.
• Fax communications cannot take place between the KX-TDA5480/KX-TDA0484 and
KX-TDA0480.
To Next Page
Loading...
