Panasonic KX-TDA0484 - Page 71

C1 Initializing the VoIP Gateway Card
Getting Started 71
4. Using the KX-TDA50 Maintenance Console, set the status of the card to OUS, then set it
back to INS.
5. Return the System Initialize Switch to the "NORMAL" position.
KX-TDA0484
1. Install the card to the KX-TDA100/KX-TDA200 PBX, and then turn on the power to the
PBX.
2. Using the KX-TDA Maintenance Console, confirm that the card is in service (INS).
3. Set the System Initialize Switch to the "SYSTEM INITIALIZE" position.
CAUTION
Do not press the Reset Button nor turn the power off then on while the System Initialize
Switch is in this position. Doing so will initialize the PBX.
4. Using the KX-TDA Maintenance Console, set the status of the card to OUS, then set it
back to INS.
5. Return the System Initialize Switch to the "NORMAL" position.
Power Switch
System Initialize Switch
Reset Button
SYSTEM
INITIALIZE
RESET
NORMAL