Panasonic KX-TDA100 - Intercept Routing-No Destination

1.9 I
Feature Manual 165
Programming References
PC Programming Manual
2.8.4 [2-3] Timers & Counters
→ Dial / IRNA / Recall / Tone—Intercept Routing No Answer (IRNA)—Day, Lunch, Break, Night
→ DISA / Door / Reminder / U. Conf—DISA—Intercept Timer—Day, Lunch, Break, Night
2.9.9 [3-5-1] Incoming Call Distribution Group—Group Settings
→ Overflow No Answer—Time out & Manual Queue Redirection—Destination-Day, Lunch, Break,
Night
2.10.1 [4-1-1] Wired Extension—Extension Settings
→ Intercept Destination
→ Intercept No Answer Time
2.10.10 [4-2-1] Portable Station—Extension Settings
→ Intercept Destination
→ Intercept No Answer Time
2.11.3 [5-3-1] Voice Message—DISA System—Option 1—DISA Intercept—Intercept when all DISA ports
are busy (MPR Software File Version 3.1000 or later)
2.16.6 [10-4] Miscellaneous
→ Intercept—Intercept Routing - Busy (Destination is busy) (not available for MPR Software File
Version 3.1000 or later)
→ Intercept—Intercept Routing - DND (Destination sets DND)
→ Intercept—Routing to Operator - No Destination (Destination is not programmed)
→ Intercept—Intercept Routing for Extension Call (MPR Software File Version 3.1000 or later)
PT Programming Manual
[203] Intercept Time
[470] Trunk Group Intercept Destination (not applicable for MPR Software File Version 3.1000 or later)
[604] Extension Intercept Destination
[625] Destination for Overflow Time Expiration
Feature Manual References
1.4.9 DND (Do Not Disturb)
1.4.7 DISA (Direct Inward System Access)
1.9.12 Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Conditions
• Intercept Routing—No Destination on/off
Intercept Routing—No Destination can be enabled or disabled for the entire system, through system
programming. If disabled, the caller will hear a reorder tone.
Note that calls received through an ELCOT/LCOT or T1 (LCOT/GCOT) card will always be directed to
an operator, even when this feature is disabled.