1.14 Q
Feature Manual 269
Feature Manual References
2.1 Capacity of System Resources
Operating Manual References
1.3.57 Quick Dialing
1.14.2 Quick Setup
Description
Basic PBX parameters can be programmed the first time the PBX is accessed with a PC using the KX-TDA
Maintenance Console software.
When the PBX is accessed with the Installer Level Programmer Code and default password (→ 1.13.3
Password Security), for the first time (i.e., accessed after the PBX's settings have been initialized or when
the PBX's settings are still set to their default values), Quick Setup will launch automatically. From here the
following basic parameters can be programmed as desired:
Item Parameter Description
Date & Time Set Year/Month/Date/
Hour/Minute
The date and time set on the PC can be used by default.
System
Password for
Installer
4–10 characters Enter the system password for installer (→ 1.13.3 Password
Security).
Operator &
Manager
Extension
Number
Assign a PBX operator. (→ 1.12.5 Operator Features) This
extension will be the operator for all time modes, and is
automatically assigned manager status to perform manager
operations. (→ 1.11.1 Manager Features)
Flexible
Numbering Type
1. Pattern 1
(with )
2. Pattern 2
(without )
Select whether or not the prefix " " must be entered before dialing
feature numbers.
[Example] Call Pickup feature number
Pattern 1 (with ): 41
Pattern 2 (without ): 41
Note that certain feature numbers (Line Access numbers, Operator
Call, etc.) never need this prefix.
For a list of the default flexible numbers, refer to the [Flexible
Numbering Table (available while a dial tone is heard)] (→ 1.6.4
Flexible Numbering/Fixed Numbering).
Extension
Number
From 101/from
201 (for KX-
TDA50/KX-
TDA100/KX-
TDA200) or from
1001/from 2001
(for KX-TDA600)
Determines the number from which default extension numbers
begin.
To Next Page
Loading...
