1.4 D
68 Feature Manual
• It is possible to assign the minimum duration of the DTMF signal sent to the CO line port which has
been set to DTMF mode.
Programming References
PC Programming Manual
2.7.11 [1-1] Slot—LCO Port
→ Dialing Mode
→ DTMF Width
→ Pulse Speed
2.7.17 [1-1] Slot—T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
→ CO Dial Mode
→ DTMF Width
→ CO Pulse Speed
PT Programming Manual
[410] LCOT Dialing Mode
[411] LCOT Pulse Rate
[412] LCOT DTMF Minimum Duration
1.4.3 Dial Tone
Description
The following dial tones inform extension users about features activated on their extensions:
Each dial tone type has two frequencies, such as dial tone 1A and dial tone 1B.
Type Description
Tone 1A/1B A normal dial tone is heard when:
a) No features listed for dial tones 2 through 4 has been set, or
b) Automatic Route Selection (ARS) is used.
Tone 2A/2B This tone is heard when:
• There are messages that have previously been listened to and no new
messages on the SVM card.*
• Any of the features below are set.
• Absent Message
•BGM
• Call Forwarding (FWD)
• Call Pickup Deny
• Call Waiting
• Do Not Disturb (DND)
• Extension Dial Lock
• Executive Busy Override Deny
• Hot Line
• Timed Reminder
To Next Page
Loading...
