Panasonic KX-TDA100 - Page 205

1.13 P
Feature Manual 205
Conditions
• Only one system programming session is permitted at a time. Access will be denied when a second
party tries to perform system programming, including system programming via a PT.
• Programmer Code and Password for System Programming
To access system programming, a programmer code and its password must be entered. For more
details, see Section 1.13.3 Password Security.
• Remote Programming Limitation
It is possible to disable remote access through system programming. Disabling this feature will also
disable the ability to perform on-site programming via modem.
• If an extension user sets Walking Extension at the same time that the extension's data is being
programmed through PC programming, the data may not be transferred properly. (→ 1.20.2 Walking
Extension)
Installation Manual References
KX-TDA50
2.5.7 RMT Card (KX-TDA5196)
3.1 Overview
3.2 Connection
3.3 Installation of the Hybrid IP-PBX PC Programming Software
KX-TDA100/KX-TDA200
2.3.1 MPR Card
2.3.3 RMT Card (KX-TDA0196)
2.6.6 CTI-LINK Card (KX-TDA0410)
3.1 Overview
3.2 Connection
3.3 Installation of the KX-TDA Maintenance Console
KX-TDA600
2.3.1 EMPR Card
2.3.3 RMT Card (KX-TDA0196)
2.8.6 CTI-LINK Card (KX-TDA0410)
3.1 Overview
3.2 Connection
3.3 Installation of the KX-TDA600 Maintenance Console
Programming References
PC Programming Manual
2.17.1 [11-1] Main
→ RS-232C—External Modem Command—Automatic Initialization
→ RS-232C—External Modem Command—Manual Initialization 1–Manual Initialization 5
→ Remote
→ Password—System Password - PC Programming—User Level
→ Password—System Password - PC Programming—Administrator Level
→ Password—System Password - PC Programming—Installer Level
PT Programming Manual