Panasonic KX-TDA100 - Page 273

1.15 R
Feature Manual 273
[Ring Tone Pattern Table]
The ring tone pattern table is categorized into three parts, each containing a specified number of pattern
plans.
The ring tone pattern table is categorized as follows:
• Incoming CO Line Calls: each pattern plan can assign a ring tone pattern for each trunk group.
→ 2.8.14 [2-8-1] Ring Tone Patterns—Call from CO
• Incoming Doorphone Calls: each pattern plan can assign a ring tone pattern for each doorphone.
→ 2.8.15 [2-8-2] Ring Tone Patterns—Call from Doorphone
• Others: each pattern plan can assign a ring tone pattern for incoming intercom calls as well as ring
tones assigned to certain features (e.g., timed reminder).
→ 2.8.16 [2-8-3] Ring Tone Patterns—Call from Others
The ring tone patterns that arrive at an extension are determined by the pattern plan that is assigned to that
extension through system programming.
[Programming Example of Ring Tone Pattern Table]
Conditions
•"PT Ring off Setting" can be enabled or disabled through system programming. If disabled, PT
users cannot turn incoming call ringing off for their extension.
Programming References
PC Programming Manual
2.8.14 [2-8-1] Ring Tone Patterns—Call from CO—Ring Tone Pattern Plan 1–8
2.8.15 [2-8-2] Ring Tone Patterns—Call from Doorphone—Ring Tone Pattern Plan 1–8
2.8.16 [2-8-3] Ring Tone Patterns—Call from Others—Extension—Ring Tone Pattern Plan 1–8
2.8.17 [2-9] System Options—Option 1—PT Operation—PT Ring Off Setting
2.10.1 [4-1-1] Wired Extension—Extension Settings—Main—Ring Pattern Table
2.10.10 [4-2-1] Portable Station—Extension Settings—Main—Ring Pattern Table
PT Programming Manual
None
Feature Manual References
2.1 Capacity of System Resources
Table
No.
Intercom
Call/Hold
Recall
CO Line Call/Hold
Recall
Doorphone Call
Timed
Reminder
Call Back LCS
External
Sensor
TRG1 TRG2 ... Port 1 Port 2 ...
1 Double Single Single
2 Single Double Double
:: ::::::: :::