Panasonic KX-TDE100

If the DHCP server is not available, change the DHCP Client setting to Disable and set fixed IP
addresses, then restart the PBX.
To change
the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet straight
cable. When connecting the PC with an Ethernet straight cable, make sure the PBX is disconnected
from the LAN and then connect the PC with an Ethernet straight cable using 192.168.0.101 for the IP
address of the IPCMPR/IPCEMPR card.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*3
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*4
Valid IP address range: "0.0.0.0" to "223.255.255.255"
PBX Web Manager
It is possible to use a PC with the Maintenance Console (PBX Unified PC Maintenance Console) installed, as
a web server. This allows users to configure the PBX via a web browser on a local client, or a remote PC
through the Internet.
PBX
Server
Client
Remote PC
IP Network
If Maintenance Console is installed on the client PC, a web server is not necessary.
PBX
Server/Client
Accessing PBX Web Manager
PBX
Web
Manager can be enabled during the installation of the Maintenance Console. It can also be enabled
in Options.
Note
• When starting
the Maintenance Console, if there is less than 80 MB of available memory, this feature
is automatically disabled.
• Only one user can access Maintenance Console or PBX Web Manager at any given time.
To start PBX Web Manager:
20 PC Programming Manual
1.2.1 Installing and Starting the Maintenance Console