129
Changing the handset name
Each handset can be given a customized name
(“Bob”, “Kitchen”, etc.). This is useful when you
make intercom calls between handsets. You can also
select whether or not the handset name is displayed
in standby mode. The default setting is “No”. If you
select “
Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1. [MENU] [#][1][0][4]
2. Enter the desired name (max. 10 characters; see
the character table, page 99).
If not required, go to step 3.
3. [SAVE]
4. : Select the desired setting. then [SELECT]
2 times
5. [OFF]
Call block (Caller ID subscribers only)
This feature allows the unit to reject calls when:
– the unit receives a call from a phone number
To Next Page
Loading...
