Main menu: “Initial setting”
Sub-menu 1 Sub-menu 2 Settings Code
Ringer setting
Ringer volume Off–6 <1> #160 30
Interrupt tone
*1, *11
<On>
Off
#201 31
Night mode
– On/Off
On <Off> #238 46
Night mode
– Start/End
<11:00 PM/
06:00 AM>
#237 46
Talking CID
(Talking Call Display)
– On <Off> #162 50
Call block
*1
– – #217 46
First ring
*1
<On>
Off
#173 48
Block w/o num
*1, *2
(Block calls without phone
number)
On <Off> #240 47
Contrast
(Display contrast)
– Level 1–6 <3> #145 –
Change language
(Display)
– <English>
Français
#110 17
Main menu: “Cust. Support”
Operation Code
Displaying customer support Web address. #680 –
*1 If you program these settings using one of the units, you do not need to program the same
item using another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 When the cellular line only mode is turned on, these menus are not displayed (page 20).
*4 After the Bluetooth device is paired, the device name is displayed.
*5 For CELL 1
*6 For CELL 2
*7 If you select one of the melody ringer tones, it will continue to play for several seconds even
if the caller has already hung up. You may either hear a dial tone or no one on the line when
you answer the call.
*8 The preset melodies in this product are used with permission of © 2009 Copyrights Vision
Inc.
*9 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select “Caller ID auto”. To turn this feature off, select
“Manual”. (Call Display subscribers only)
To use this feature, set the date and time first (page 17).
44
Programming
To Next Page
Loading...
