*10 If you subscribe to a distinctive ring service, select a tone (tone 1 to 3). If you select a
melody, you cannot distinguish lines by their ringers.
*11 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select “On”, the tone sounds 2 times.
*12 This setting is available when you have the key detector (KX-TGA20). Read the installation
guide for more information on the key detector.
*13 For models with supplied key detectors, the display shows “1: Detector1”.
*14 If you register 2 or more key detectors.
*15 If you have 2 or more key detectors.
*16 Turn this feature off if you prefer not to hear key tones while you are dialing or pressing any
keys, including confirmation tones and error tones.
*17 If you subscribe to a Call Display service and want to view the caller’s information after lifting
up the handset to answer a call, turn off this feature.
*18 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*19 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to “A” if telephone line condition is not good.
*20 This setting is available when a cellular phone is paired.
*21 KX-TG7871 series: page 3
*22 This setting is available when a headset is paired.
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R Set the date and time beforehand
(page 17).
Handset
1 MMENUN#720
2 MbN: Select the desired alarm option. a
MSELECTN
“Off” Turns alarm off. Go to
step 7.
“Once” An alarm sounds once at
the set time.
“Daily” An alarm sounds daily at
the set time. Go to step 4.
3 Enter the desired month and date. a
MOKN
4 Set the desired time.
5 *: Select “AM” or “PM”. a MOKN
6 MbN: Select the desired alarm tone. a
MSELECTN
R We recommend selecting a different
ringer tone from the one used for
outside calls.
7 MSELECTN a MOFFN
R When the alarm is set, is displayed.
Note:
R To stop the alarm, press MOFFN or place
the handset on the base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Night mode
Night mode allows you to select a period of
time during which the handset and/or base
unit will not ring for outside calls. This feature
is useful for time periods when you do not
45
Programming
To Next Page
Loading...
