Pr4.37
Range Default Unit
0 – 10000 0 1ms
Pr4.38
Range Default Unit
0 – 10000 0 1ms
Pr4.39 Brake release speed setup
Range Default Unit
30 – 3000 30 r/min
Pr4.40 Warning output 1 selection
Range Default Unit
0 – 11 0 -
Pr4.41 Warning output 2 selection
Range Default Unit
0 – 11 0 -
Alarm Content
[0] ---
1 Overload protection Load factor is 85% or more the protection level.
2 Over-regeneration alarm
3 Battery alarm Battery voltage is 3.2V or lower.
4 Fan alarm Fan has stopped for 1 sec.
5
6 Encoder overheat alarm The encoder detects overheat alarm.
7 Oscillation detection alarm Oscillation or vibration is detected.
8 Lifetime detection alarm Life expectancy of capacitor or fan become short.
9
Pr4.42
Range Default Unit
0 – 262144 10 -
* for more detail please refer Panasonic A5 manual
Mechanical brake action at stalling
setup
Mechanical brake action at running
setup
Setup
Value
Ored of all alarms.
Regenerative factor is 85% or more the protection
level.
Encoder communication
Alarm
The number of successive encoder communication
errors exceeds the specified value.
2
nd
in position range
To Next Page
Loading...
