What to do if Panasonic MINAS A6 Servo Drives motor does not run?
If your Panasonic Servo Drive motor isn't running, first, ensure the power is on. Second, check for any loose connections. Finally, consult the section 'Display of Factor of No Motor Running' in the Preparation chapter to identify the root cause and take appropriate actions.
Why is the rotation unstable (not smooth) on my Panasonic MINAS A6 Servo Drives?
If you're experiencing unstable or not smooth rotation with your Panasonic Servo Drives, check if an error code is being displayed. Also, verify that the parameter setups are correct.
General| Protection Class | IP20 |
|---|---|
| Position Control | Yes |
| Speed Control | Yes |
| Torque Control | Yes |
| Type | Servo Drives |
| Input Voltage | Single-phase 200 V AC, Three-phase 200 V AC |
| Communication Interface | MECHATROLINK-III, Modbus RTU, RS-485 |
| Full-closed Control | Yes |
| Vibration Suppression Control | Yes |
| Feedback System | 20-bit Absolute Encoder |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overload, Encoder Error |
| Ambient Operating Temperature | 0°C to 55°C |
| Storage Temperature | -20°C to 80°C |
| Cooling Method | Self-cooling, Forced air cooling (depending on the model) |
| Ambient Humidity | 90% RH or less (non-condensing) |
To Next Page
