Panasonic MINAS A6 Series - EEPROM Writing Mode

2-97
1
Before Using the Products
2
Preparation
3
Connection
4
Setup
5
Adjustment
6
When in Trouble
7
Supplement
Caution
1. When writing error occurs, make writing again. If the writing error repeats many times,
this might be a failure.
2. Don't turn off the power during EEPROM writing. Incorrect data might be written. If
this happens, set up all of parameters again, and re-write after checking the data.
3. When the error dened by Err11.0 “Under voltage protection of control power supply”
occurs, is displayed indicating that no writing is made to EEPROM.
2
Preparation
14. How to Use the Front Panel
EEPROM Writing Mode
(SET button)
“ ” increases while
keep pressing (for
approx. 5sec) as the
right fig. shows.
When you change the parameters which
contents become valid after resetting,
will be displayed after finishing
wiring. Turn off the control power once to
reset.
• Keep pressing until the display
changes to when you
execute writing.
* “Start” flashes instantaneously and is
difficult to check visually.
• To write the parameter to EEPROM, press
to change to EXECUTION display.
(Mode switch button)
(Mode switch button)
Writing completes
Writing error
Starts writing.
SELECTION display
EEPROM Writing Mode
SELECTION display
Parameter Setup Mode
SELECTION display
Auxiliary Function Mode
EXECUTION display
Note
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com