5-14
Parameters set/changed by real-time auto-gain tuning
• Parameters which are updated
The real-time auto-tuning function updates the following parameters according to
Pr0.02 Real-time auto-tuning setup by using the load characteristic estimate values.
Class No.
Title Function
0 04 Inertia ratio
Updates this parameter when the real-time
auto-tuning is enabled (Pr0.02 = 1 to 4).
6 07 Torque command additional value
Updates this parameter when the real-time
auto-tuning is in the quick response mode 2,
3 (Pr0.02 = 3, 4).
6 08
Positive direction torque compen-
sation value
Updates this parameter when the real-time
auto-tuning is in the quick response mode 3
(Pr0.02 = 4).
6 09
Negative direction torque compen-
sation value
6 50 Viscous friction compensation gain
•
Parameters which are updated to setup value corresponding to stiffness setup
The real-time auto-tuning function updates the following basic gain setup parameters
according to Pr0.03 Real-time auto-tuning stiffness setup.
Class No.
Title Function
1 00 1st gain of position loop
When real-time auto-tuning is valid (Pr0.02
= 1 to 4), updates the setup value according
to the stiffness.
Refer to P.5-9 Basic gain parameter setup
table.
1 01 1st gain of velocity loop
1 02
1st time constant of velocity loop
integration
1 04 1st time constant of torque lter
1 05 2nd gain of position loop
1 06 2nd gain of velocity loop
1 07
2nd time constant of velocity loop
integration
1 09 2nd time constant of torque lter
2 22 Command smoothing lter When real-time auto-tuning is valid (Pr0.02
= 1 to 4), updates the setup value according
to the stiffness.
*
For velocity control, primary lter is xed.
6 48 Adjust lter
• Parameters which are set to fixed value
Real-time auto-tuning function sets the following parameters to xed value.
Class No.
Title
Setup value
1 03 1st lter of speed detection
0
1 08 2nd lter of speed detection
1 10 Velocity feed forward gain 1000 (100 %)
1 11 Velocity feed forward lter 0
1 12 Torque feed forward gain 1000 (100 %)
1 13 Torque feed forward lter 0
6 10 Function expansion setup 2 bit4=1
6 49 Adjust/Torque command attenuation term 15
2. Real-Time Auto-Gain Tuning
Two-degree-of-freedom control mode – Standard type
Related page
•P.4-6 to P.4-85... “Details of parameter”
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
