Panasonic MINAS A6 Series - Two-Degree-Of-Freedom Control Mode (Full-Close Control)

5-65
1
Before Using the Products
2
Preparation
3
Connection
4
Setup
5
Adjustment
6
When in Trouble
7
Supplement
5
5. Manual Gain Tuning (Application)
Adjustment
Two-degree-of-freedom control mode (full-close control)
Outline
The two degree-of-freedom control mode is an extended function of full-close control
mode to improve the responsiveness by making it possible to independently set the com-
mand response and servo rigidity.
Applicable Range
This function can be applicable only when the following condition are satised.
Conditions under which
the Two-degree-of-freedom control mode is activated.
Control Mode •Full-close control
Others
• Should be servo-on condition.
• Elements other than control parameters, such as torque limit, etc. are
properly set and the motor is free of obstacle to normal motor rotation.
Related
Parameter
First of all, with Pr6.47 write “Function expansion setting 2” = 1 into EEPROM, and then,
make the two degree-of-freedom control mode enabled by resetting the control power
supply.
Thereafter, adjust by the real-time auto-tuning (refer to 5-1-3). Only when further im-
provement is required, nely adjust the following parameters manually while checking the
responses.
Class No. Title Function
6 47
Function
expansion
settings 2
Set up various functions bit by bit.
bit 0 Two-degree-of-freedom control mode
0: Invalid 1: Valid
bit 3 Two degree-of-freedom control real-time auto-tuning select
0: Standard type 1: Synchronous type
*
The least signicant bit is represented by bit0.
*bit 3 (two-degree-of-freedom control real-time auto-tuning
chosen) becomes enabled only when bit 0 is set to 1: Enabled.
2 22
First order
lter time
constant for
command
While the two-degree-of-freedom control real-time auto-tuning
is selected, time constant of command lter is applied with the
maximum value limited to 640 (= 64.0 ms).
(The value of the parameter is not limited but the value to be
applied to driver is limited.)
Decreasing the value of this parameter makes command
response fast and large, resulting smooth command response.
6 48 Adjust lter
Sets time constant of adjustment lter.
When the torque lter setting is changed, set the parameter to a
value close to real-time auto-tuning setting.
Fine adjustment by checking positional deviation of the
encoder near setting point may improve overshoot or oscillatory
waveform.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com