21
Important notice about "Error Code List"
1) About "*" indication:
The third digit from the left is different as follows.
• In case of 0 (example: 18 0
01000)
When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has been
completed.
It means that this error is occurred basically at user side.
• In case of 8 (example: 18 8
01000)
When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has been released.
(Example; Factory assembling-line before unit shipment, Service mode etc.)
It means that this error is occurred at service side.
2) About "?" indication: ("18*0 0?01" to "18*0 0?50"):
The third digit from the right shows one of the hexadecimal ("0" to "F") character.
• Step 3. How to exit from Error Code display mode
Simply, turn the power off. (Since Error code display mode is executed under the condition of temporary cancellation of
"INITIAL SETTINGS", it wake up with normal condition when turn off the power.)
Note:
The error code can not be initialized.
To Next Page
Loading...
Need help?
General
