36
9.4. Lens Disassembly Procedure
Precaution:
1. Do not remove the MOS when disassembling or re-
assembling the lens in order to maintain it clean.
When remove it, refer to item "9.6".
2. Keep dust or dirt away from the lens.
3. To remove dirt or dust from the lens, blow with dry air.
4. Do not touch the lens surface.
5. Use lens cleaning KIT (BK)(VFK1900BK).
9.4.1. Removal of the Master Flange Unit
1. Unscrew the 1 screw (A) to remove the sensor of Zoom
Motor.
2. Unscrew the 2 screws (B) to remove the sensor of Focus
Motor.
3. Unsolder 4 points to remove the Focus Motor FPC.
4. Unsolder 18 points to remove the Shutter FPC from Lens
FPC Unit.
5. Unsolder 2 points to remove the Lens FPC Unit.
6. Unscrew the 6 screws (C) to remove the Master Flange
Unit.
9.4.2. Both Side Cam Frame, 1st Lens
Unit, 2nd Lens Unit and 3rd Lens
Unit
1. Pull out the Relay Gear using tweezers, etc.
2. Turn the Gear of Fix Frame Unit using Slotted Driver, etc.
in the direction of arrow.
3. Push the 1st Lens Frame Unit to the indicated by arrow
from lens side, then remove the unit of Both Side Cam
Frame Unit, 1st Lens Frame Unit, 2nd Lens Frame Unit
and 3rd Lens Unit from Fix Frame Unit.
To Next Page
Loading...
