40
9.5.4. Insert the Fix Frame Unit
Note: (When Installing)
When using the Fix Frame Unit of service part, remove the
Master Flange Unit (used to prevent fall of the gear) and the
Relay Gear before assembling the Fix Frame Unit.
1. Align the Zoom Motor of the Fix Frame Unit with the
Shutter FPC, then put the each Cam Pin of the Both Side
Cam Frame Unit in the each Groove of Penetration Cam
Frame.
2. Insert the Relay Gear to the Fix Frame Unit.
9.5.5. Insert the Master Flange Unit
Note: (When Installing)
Take Care not to damage the flex.
Take Care not to tuck in to the Master Flange Unit, When
inserting the Shutter FPC.
1. Push the Hole of the Shutter FPC to the Boss of the
Master Flange Unit tightly.
2. Place the Shutter FPC following the Guide of the Fix Cam
Frame, and install the Master Flange Unit to the Unit of
Both Side Cam Frame Unit, 1st Lens Frame Unit, 2nd
Lens Frame Unite, 3rd Lens Frame Unit and Fix Frame
Unit.
3. Check if the positioning boss of the Shutter PFC and shaft
of the Master Flange Unit are inserted into the designated
hole of the Both Side Cam Frame Unit.
To Next Page
Loading...
Need help?
General
