157
6. Stabiliser, Zoom and Flash
∫ The available flash range (approximation)
When you use certain lenses, light from the flash may be
blocked or fail to cover the lens field of view, causing dark
areas to appear in the resulting pictures.
The distance at which light from the flash is blocked by lens, and
the distance to which light from the flash is delivered vary
depending on the lens used. Check the distance to the subject
when taking a picture.
•
These are the ranges when the ISO sensitivity is set to [AUTO] and [ISO Limit Set] (P201) is
set to [OFF].
• Do not bring the flash too close to objects or close the flash while it is activated. The objects
may be discoloured by its heat or lighting.
• Do not close the flash soon after the flash is activated prior to taking pictures due to Forced ON/
Red-Eye Reduction etc. It causes a malfunction.
• It may take time to charge the flash if you repeatedly take pictures. You must wait a moment to
take the next picture while the flash icon is blinking red indicating the flash is charging.
• When you attach an external flash, it takes priority over the built-in flash. Refer to P307 for the
external flash.
When the interchangeable lens (H-FS12032) is used
Wide Tele
0.4 m (1.3 feet) to 4.8 m (16 feet) 0.3 m (0.98 feet) to 3.0 m (9.8 feet)
When the interchangeable lens (H-FS35100) is used
Wide Tele
0.9 m (3.0 feet) to 4.2 m (14 feet) 0.9 m (3.0 feet) to 3.0 m (9.8 feet)
When the interchangeable lens (H-H020A) is used
0.5 m (1.6 feet) to 9.8 m (32 feet)
When the interchangeable lens (H-FS14140) is used
(When the aspect ratio is [4:3].)
Wide to 34 mm 35 mm Tele
Vignetting effect occurs due to
the light of the flash.
1.0 m (3.3 feet) to 3.7 m
(12 feet)
0.5 m (1.6 feet) to 3.0 m
(9.8 feet)
To Next Page
Loading...
Need help?
General
