57
Taking Pictures with Burst Mode
By continuously pressing the shutter button, it
is possible to record in burst mode. (4
frames/second maximum of 8 frames)
[Preparation]
• Set the REC mode dial. (P25)
1
Set the operational mode dial to burst
mode [ ].
2
Press the shutter button halfway to
lock the focus, then press it fully to
take pictures in sequence.
• It is possible to record 4 frames in 1 second in
burst mode, at a shutter speed higher than 1/25,
but the flash does not fire simultaneously.
• If the flash fires, it is possible to record only 1
frame.
• When quality is set to TIFF [ ], it is not
possible to use the burst mode.
• When quality is set to fine [ ], it is possible to
record a maximum of 4 frames in burst mode .
• In motion image mode [ ], the burst mode
cannot be used.
• Only the first picture recorded is displayed on the
LCD monitor.
KC3‑PP.book57ページ２００２年４月５日 金曜日 午前１１時５５分
To Next Page
Loading...
