Panasonic Lumix DMC-LC40

78
Using the Auto Review
Recording with the auto review set to [ON],
the recorded picture is automatically
displayed on the LCD monitor for about 2
seconds.
[Preparation]
Set the operational mode dial to REC mode
(single mode [ ] or burst mode [ ]).
1
Press the [MENU] button.
2
Press 1 to open the setup menu .
3
Press 3/4 to select [AUTO REVIEW] .
4
Press 2/1 to select [ ON].
5
Press the [MENU] button.
• The menu will disappear.
• In burst mode [ ] or auto bracket, only the first recorded picture is displayed.
• Even when setting the auto review to [ON], it is not available in motion image mode [ ].
• When recording in burst mode [ ], auto bracket, TIFF or still picture with audio modes,
the auto review is set to [ON].
REC
SETUP
MONITOR
AUTO REVIEW
BEEP
POWER SAVE
NO. RESET
CLOCK SET
SELECT:
SET
EXIT
2 MIN.
KC3‑PP.book78ページ２００２年４月５日 金曜日 午前１１時５５分