233
SQW0740
Wi-Fi
Operating the camera by connecting it to a smartphone
Using a password to set up a connection
When [Wi-Fi Password] is set to [ON], you can strengthen security by using manual input
or a QR code for password authentication.
Preparation
(On the camera) Set [Wi-Fi Password] to [ON]. (→266)
■
When reading a QR Code to connect
(On the camera)
→ [Setup] → [Wi-Fi] → [Wi-Fi Function] → [New Connection]
→ [Remote Shooting & View]
SSID and Password
QR Code
• The information (QR Code, SSID and Password) required for
directly connecting your smartphone to this unit is displayed.
• You can also display the information by pressing [Wi-Fi] button on
the camera.
(On your smartphone)
Start “Image App” (→231)
Select “QR code”
• When the smartphone is connected to a wireless access point, it may take time to display QR
code.
• (For iOS devices) A confirmation screen will be displayed. Select [OK] to proceed.
Use the “Image App” to scan the QR code displayed on the screen of the camera
• If you press [MENU/SET] on the camera, the QR code will be enlarged.
• For iOS devices only
Install the profile
• If the smartphone is locked with a passcode, enter the passcode to unlock the smartphone.
Press the home button to close the browser
Turn on the Wi-Fi function in the setting menu
On the Wi-Fi setting screen, select the SSID displayed on the
camera
Start “Image App” (→231)
• (iOS devices) Steps
through are not required from the second
time on.
To Next Page
Loading...
Need help?
General
