238
SQW0740
Wi-Fi
Operating the camera by connecting it to a smartphone
Sending pictures in the camera to social networking services
1
Connect to a smartphone (→232)
Switch the
device of the
pictures to be
displayed
2
Operate the smartphone
Select [ ]
• You can switch a device of pictures to
be displayed using the icon at the top
left on the screen. Select [LUMIX] to
display a picture saved in the camera.
Press and hold the picture and drag
it to send it to the social networking
service, etc.
• The picture will be sent to the social
networking service or other WEB
services.
Adding location information to pictures in the camera from a
smartphone
You can send the location information acquired from a smartphone to the camera. After
the information is sent, you can write it on the pictures in the camera.
GPS
Starts location information recording
Start the recording
Ends location information recording
Sends and writes the location
information
• You can also use [Location Logging] in the [Playback] menu to write the sent location
information to the pictures.
• Location information that is different from the information acquired during recording may
be written. Take care regarding the following matters.
– Set [Home] of [World Time] of the camera to your home area.
– Once a smartphone starts recording the location information, do not change the
[Home] setting of [World Time] of the camera.
• The location information cannot be written to pictures recorded without setting [Clock
Set].
To Next Page
Loading...
Need help?
General
