GPS and map functions
DMC-TZ40
DMC-TZ41
Using the compass
VQT4T12
- 186 -
Adjusting the compass
When the [×] appears on the compass, please perform [Calibrate compass].
Select [Calibrate compass] from [Setup] menu and press
[MENU/SET]
Hold this unit vertically, and circle it in a figure 8 a few times
by twisting your wrist
• When adjustment is successful, a message appears indicating the completion of
the adjustment.
●
To avoid dropping the camera, always wear the hand strap on your wrist and
perform adjustment.
●
If adjustment failed, move to a place nearby that is unaffected by magnetism, then
adjust again.
●
When you are unable to obtain the direction, such as when there is something that is
emitting strong magnetism, a [×] is displayed in the compass.
To Next Page
Loading...
