6 Disassembly Instructions
TOP PREVIOUS NEXT
Warning:
● Be sure to unplug the power cord from the power outlet before disassembling this projector.
Caution:
● While turning over a printed circuit board, be sure to put a insulating material under it to
prevent a short circuit.
● Printed circuit boards and wires must not be pulled forcibly, but be handled carefully.
● Connectors also must be handled carefully.
● After repairing this projector, be sure to put back the wires and connectors to the original
condition.
6.1 Printed Circuit Board and Main Parts Location
6.2 Removal of Upper Case
6.3 Removal of A-P.C.Board
6.4 Removal of S-P.C.Board
6.5 Removal of J-P.C.Board (PT-AE700E only)
6.6 Removal of B / Q-Module
6.7 Removal of P-Module
6.8 Removal of K-P.C.Board
6.9 Removal of Lamp Unit
6.10 Removal of Analysis Block and Projection Lens
To Next Page
Loading...
