6.16 Replacement of Projection Polarizer
TOP PREVIOUS NEXT
1. Remove the LCD block according to the section 6.11. "Removal of LCD Block".
2. Remove the projection polarizer which requires replacing.
(The projection polarizer is adhered with the adhesive tape.)
Note:
❍ Be careful not to damage peripheral components (prism, LCD panel, etc.).
❍ Use tweezers.
3. Install new projection polarizer.
A. Put adhesive tape on the projection polarizer.
B. Adhere the projection polarizer on the specified position.
Notes:
■ Align the projection polarizer with the guides (lower, side) of LCD block.
■ Be careful not to touch the surface of projection polarizer.
■ Use tweezers.
C. Press the adhesive part and secure the projection polarizer.
To Next Page
Loading...
