7.5.2 Preparation
TOP PREVIOUS NEXT
1. Remove the upper case and the connector cover according to the steps 1 through 2 in the
section 6.3. "Removal of A-P.C.Board".
2. Unscrew the 2 screws.
3. Connect the service kit (extension cables).
❍ Each flexible cable of LCD Panels (R/G/B) - Connectors (A1/A2/A3) on A-P.C.Board
❍ Ballast block [Connector (Q3) on Q-Module] - Connector (A4) on A-P.C.Board
❍ Intake fan connector - Connector (A15) on A-P.C.Board
❍ PBS fan connector - Connector (A18) on A-P.C.Board
4. Covering with an insulator (cloth or the like) to prevent a short circuit, set the A-P.C.Board
block on the main unit.
Note:
● Handle with care not to apply external force to connecting parts which connect the main unit
and A-P.C.Board.
To Next Page
Loading...
