6.13 Replacement of LCD Panel
TOP PREVIOUS NEXT
● The procedure is described as an example of LCD panel (B).
1. Remove the LCD block according to the section 6.11. "Removal of LCD Block".
2. Cut the 4 LCD panel installation spindles at the position A and remove the LCD panel.
3. Cut the 4 LCD panel installation spindles at the position B and remove them.
Notes:
❍ Work carefully not to apply external force around the spindle part by using a cutter,
cutting nipper or the like for cutting the spindle.
❍ Adjust the height after the spindle is cut to 1 mm or less.
4. Attach the base plate with 4 screws.
5. Tighten the 2 screws temporarily just until new LCD panel (with the panel attachment and
panel adjuster) can be shifted by your fingers.
To Next Page
Loading...
