6. Reassemble the projector in the reverse order of disassembling, but leave the upper case and
the screws fixing the A-P.C.Board block as they are removed.
7. Adjust the convergence according to the section 7.4. "Convergence Adjustment".
8. After the adjustment, while paying attention not to vary the adjusting result, tighten the 2
screws (upper) fixing the panel attachment temporarily with a hexagon head wrench.
Note:
ā Prepare a hexagon head wrench processed short.
9. Remove the LCD block again.
10. Tighten the 3 screws fixing the panel attachment.
To Next Page
Loading...
