6.18 Replacement of Incidence Polarizer (G)
TOP PREVIOUS NEXT
1. Remove the A-P.C.Board block according to the steps 1 through 3 in the section 6.3.
"Removal of A-P.C.Board".
2. Mark positions of the incidence polarizer (G).
Note:
ā Mark accurately as possible because the marks will be used for resetting the incidence
polarizer position.
3. Unscrew the 1 screw and remove the incidence polarizer.
4. Attach a new incidence polarizer and align it with the mark.
5. Tighten the 1 screw polarizer with care not to move the incidence polarizer position.
TOP PREVIOUS NEXT
To Next Page
Loading...
