Panasonic PT-MZ680 - Page 156

Chapter 5 Operations — Web control function
156 - ENGLISH
1
2
3
4
5
6
Network security
Crestron tools
1 [ENABLE]
Select [Enable] to use the E-mail function.
2 [SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail server
(SMTP). To enter the server name, the DNS server needs to be
set up.
3 [MAIL FROM]
Enter the E-mail address of the projector. (Up to 63 characters in
single byte)
4 [MEMO]
Enter information such as the location of the projector that noties
the sender of the E-mail. (Up to 63 characters in single byte)
5 [MINIMUM TIME]
Change the minimum interval for the temperature warning E-mail.
The default value is 60 minutes. In this case, another E-mail will
not be sent for 60 minutes after sending the temperature warning
E-mail even if it reaches the warning temperature.
6 [INTAKE AIR TEMPERATURE]
Change the temperature setting for the temperature warning
mail. A temperature warning E-mail is sent when the temperature
exceeds this value.
8
7
9
8
7
Network security
Crestron tools
Network security
Crestron tools
7 [E‑MAIL ADDRESS 1], [E‑MAIL ADDRESS 2]
Enter the E-mail address to be sent. Leave [E-MAIL ADDRESS 2]
blank when two E-mail addresses are not to be used.
8 Settings of the conditions to send E-mail
Select the conditions to send E-mail.
[MAIL CONTENTS]:
Select either [NORMAL] or [SIMPLE].
[ERROR]:
Send an E-mail when an error occurred in the self-diagnosis.
[INTAKE AIR TEMPERATURE]:
Send an E-mail when the intake air temperature has reached the
value set at the above eld.
[PERIODIC REPORT]:
Place a check mark on this to send an E-mail periodically.
It will be sent on the days and time with the check mark.
9 [Submit]
Update the settings.
[Authentication set up] page
Set the authentication items when POP authentication or SMTP authentication is necessary to send an E-mail.
Click [Detailed set up]
→
[Authentication set up].
1
2
3
4
5
6
7
8
Network security
Crestron tools