Panasonic PT-MZ680

Chapter 3 Basic Operations — Switching on/off the projector
58 - ENGLISH
9) Press the <FOCUS> button again to adjust the focus. (
x
page 60)
10) Press the <ZOOM> button again to adjust the zoom to match the projected image size to the screen.
Note
f
When the projector is switched on for the rst time after purchase, as well as when the [PROJECTOR SETUP] menu → [INITIALIZE] →
[ALL USER DATA] is executed, the focus adjustment screen is displayed after projection starts, and then the
[INITIAL SETTING]
screen is
displayed followed by the
[ADMINISTRATOR ACCOUNT]
screen. When the [PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/
E-MAIL] is executed, the
[ADMINISTRATOR ACCOUNT]
screen is displayed after projection starts. For details, refer to “When the initial
setting screen is displayed” (
x
page 52) and “When the administrator account setting screen is displayed” (
x
page 55).
Switching off the projector
1)
2)
1)
4)
3)
2)
1) Press the power <
v
/
b
> button.
f
The
[POWER OFF(STANDBY)]
conrmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the power <
v
/
b
> button again.)
f
Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f
For approximately ve seconds after the projector is turned off, the indicator does not light up even if the power is turned on.
f
Even when the power <
v
/
b
> button is pressed and the projector is switched off, the projector consumes power if the main power
of the projector is on.
When the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY MODE] is set to [ECO], use of some functions is restricted,
but the power consumption during standby mode can be conserved.
f
While projecting, the power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reected.